I added to the TC's toolbar a button that should switch 8.3-names on/off (the cm_SwitchLongNames command).
But when I press the button, nothing happens, just a beep.
BTW, button is always in "pressed state".
P.S.: Near it I added cm_SwitchHidSys, it works fine.
The cm_SwitchLongNames command
Moderators: Hacker, petermad, Stefan2, white
-
StickyNomad
- Power Member
- Posts: 1933
- Joined: 2004-01-10, 00:15 UTC
- Location: Germany
Both cm_Switch83Names and cm_SwitchLongNames works fine here too when used in the buton bar.
Maybe you have misspelled the command
Maybe you have misspelled the command
License #524 (1994)
Danish Total Commander Translator
TC 11.51 32+64bit on Win XP 32bit & Win 7, 8.1 & 10 (22H2) 64bit, 'Everything' 1.5.0.1391a
TC 3.60b4 on Android 6, 13, 14
TC Extended Menus | TC Languagebar | TC Dark Help | PHSM-Calendar
Danish Total Commander Translator
TC 11.51 32+64bit on Win XP 32bit & Win 7, 8.1 & 10 (22H2) 64bit, 'Everything' 1.5.0.1391a
TC 3.60b4 on Android 6, 13, 14
TC Extended Menus | TC Languagebar | TC Dark Help | PHSM-Calendar
Hm... actually... After restarting TC it works fine.
I could't restart it before this moment (I was downloading a large amount of data from a very-low-bandwidth ftp). I tried only to remove-and-re-add the button several times (not helped). But after restarting TC it works fine.
I could't restart it before this moment (I was downloading a large amount of data from a very-low-bandwidth ftp). I tried only to remove-and-re-add the button several times (not helped). But after restarting TC it works fine.
Last edited by sasha1024 on 2008-01-04, 13:03 UTC, edited 1 time in total.