DXF Viewer (WLX) 1.5.0.0

[AkulaBig]

Found one location. That's how it looks now: Image: https://i.ibb.co/FbydjK6K/multi-page-1.png

Yes, that's right.

[tbeu]

Finally, I think I also fixed the other location: Image: https://i.ibb.co/qFyft8Ld/multi-page-2.png

[AkulaBig]

Finally, I think I also fixed the other location: Image: https://i.ibb.co/qFyft8Ld/multi-page-2.png

No. Now again both shadings are shown incorrectly.

[tbeu]

Not sure what you mean, to me hatch 54CA42 seems as expected if compared to Image: https://i.ibb.co/MkjgXvKd/2026-06-04-071004.png

[AkulaBig]

Not sure what you mean, to me hatch 54CA42 seems as expected if compared to Image: https://i.ibb.co/MkjgXvKd/2026-06-04-071004.png

1.2.1.0:
[img]https://i.ibb.co/dsYpNRd3/2026-06-08-211038.png[/img]
1.2.0.0:
[img]https://i.ibb.co/KpkKbGhF/2026-06-08-211243.png[/img]
Where is the version that showed one hatch correctly? I don't understand anything.
Unfortunately, I no longer have time to test your plugin
Version 1.2.1.0 is much faster than 1.2.0.0. Twice or more. But slower than CADView.

[tbeu]

Where is the version that showed one hatch correctly? I don't understand anything.

Sorry. The last two screenshots were taken from my internal develop version to report progress only.

Unfortunately, I no longer have time to test your plugin

Good to know. I also need to settle dev process.

Version 1.2.1.0 is much faster than 1.2.0.0. Twice or more. But slower than CADView.

But cheaper.

[AkulaBig]

Hatches are displayed normally.

[tbeu]

Hatches are displayed normally.

Thanks for confirmation.