[TC10.50b7 64-bit] buttons invisible in conf-Font after changing to normal mode

[white]

Not confirmed on Windows 11. Are there special steps needed like opening the dialog in dark mode first?

No special steps. Clean ini and start TC, that's it.
I use Windows 11 too.

[petermad]

Not confirmed on Windows 11. Are there special steps needed like opening the dialog in dark mode first?

I don't know about Windows 11, but in Windows 10 and 7 just open TC 10.50b8 x64 in normal mode and open the Font configuration dialog as shown here: https://i.ibb.co/HnJDYVz/TC10-50b8-64bit-normal-mode-Conf-Font-Group-box-border-bug.png.

Maybe it is easier to see here (from Windows 7): https://madsenworld.dk/tcmd/fontslines.png

There are both vertical line extensions above the boxes (at red arrows pointing up) and little one-pixel displacements of the lines (at red arrows pointing down). I don't see the 1-pixel displacements under Windows 10.

32bit TC does not show these bugs. I can reproduce it with a clean ini file. TC 10.50b7 x64 does NOT have this bug

[ghisler(Author)]

I tried in Windows 7 in the VirtualBox emulator with and without themes, no problems.
Anyway, I will change the way how these lines are being drawn. It may look a little worse, though.

[white]

I tried in Windows 7 in the VirtualBox emulator with and without themes, no problems.
Anyway, I will change the way how these lines are being drawn. It may look a little worse, though.

What's the difference between beta 8 and beta 7 where the problem does not occur?

[petermad]

What's the difference between beta 8 and beta 7 where the problem does not occur?

Good question.

[white]

In normal mode, the border of the group boxes is not drawn correctly. See screenshot.

TC10.50b8 64bit normal mode only.

Tested OK using TC10.50rc1 64bit.

[petermad]

Code: Select all

07.06.22 Fixed: Configuration - Options - Font: Always draw separator lines manually, not only in dark mode (64)

Confirmed fixed in TC 10.50rc1