Page 1 of 1
selecting drive by parallel thread
Posted: 2009-04-21, 14:51 UTC
by SailorMax
Can you make selecting drive by parallel thread? If selected drive is not accesible, for example bad CD/DVD, Total Commander is "Not Responding" without possible cancel this operation...
Posted: 2009-04-21, 17:00 UTC
by ghisler(Author)
Please add:
wincmd.ini
[Configuration]
threadfindfirst=1
I'm considering to make this the default, what do you think?
Posted: 2009-04-24, 10:35 UTC
by SailorMax
I don't see any difference with this setting... When trying open CD-drive, where is no disk inside, Total commander _totaly_ is not accessible, while one of panel trying load disk content... And I can't change my choice and change disk, while this operation is not finished...
Posted: 2009-04-24, 11:36 UTC
by ebayda
I have the same behavior.
Posted: 2009-04-24, 12:11 UTC
by HaPe
Same for me. Empty CD drive freezes TC for about 10s.
threadfindfirst=1 is set in the wincmd.ini
Posted: 2009-04-24, 16:42 UTC
by ghisler(Author)
Maybe a virus scanner is causing this? Here it takes only one second (XP SP3).
Posted: 2009-04-25, 14:33 UTC
by SailorMax
tryed on Windows Vista with NOD32, and Windows 7 without any antiviruses.