Total Commander

I would like to the ability in Synchronize Directories to have the same functionality as Multi-Rename to be able to Load/Save settings.

It is possible but not with F2.
Just click the folder with the blue star. (on the top right)

Thanks for the info. Not sure if this has changed but on 7.50 pb1, the yellow folder with the blue star is located in the upper left corner, not the right corner.

Is there a way I can run this from the command line with one of the saved settings and to give it parameters to run also?

margolis22 wrote:Is there a way I can run this from the command line with one of the saved settings and to give it parameters to run also?

For buttons and internal command line:

SYNCOPEN <sync operation>=-6;Open stored sync operation

Commandline parameter for loading from outside of Total Commander:

/S=S Start "Synchronize dirs" directly, accepts two paths as parameters, or alternatively a settings name in the form /S=S:SettingsName

When I use the /S=S command line parameter TC opens up the "syncronize dirs" dialog but it doesn't start the synchronization. Is it possible to also start the synchronization from the command line?

No.