Hotkey problem

[anda]

I've been searching this forum and search engine but my question is still unanswered so I'm gonna ask here. I'm using some hotkeys in macro's / AHK,in this case specifically NUM+ and NUM- (vol up/down) on numeric keypad. It worked before but after reinstall it does not.

When I press those buttons it works except when TC is active because I get expand/shrink selection instead.

Have checked hotkeys in TC and ultra TC hotkey editor but no solution. Same problem with x86 and x64. Is there anything I have overlooked or anyone around to help to solve it if possible?


thankyou,
anda
-----------
running my reg TC on windows 10 x64 in admin mode. DiskDirExtended as only addon.

[Dalai]

running [...] TC [...] in admin mode.

That is most likely the problem. Either you run TC normally, i.e. not as admin (recommended), or you run your AHK scripts as admin.

Regards
Dalai

[anda]

You are absolutely right. Admin mode was the culprit. Somehow I tested all kind of settings except the admin mode,overlooked

thank you Dalai

regards
Anda

[Hacker]

anda,
Enable interaction with administrative programs - Scripts and Functions - AutoHotkey Community
Run with UI Access - AHK Help
How do I work around problems caused by User Account Control (UAC)? - AHK Help

HTH
Roman

[anda]

Have another -similar- problem so I use the same thread.

Am using the freeware 'Note My File' a lot http://www.softpedia.com/get/System/OS-Enhancements/Note-My-File.shtml. Works when TC in admin mode but without admin it doesn't work in program files and other 'system' dirs.

Saw Hacker give soms tips (thank you) but don't see a solution for this.
Any help appreciated.

regards
Anda