Total Commander

I'm using the CRC Checksum feaure. The Verify output is quite spartan.
So I will apreciate if there will be functions to filter the output. View output by type. Erros, not found, wrong checksum.

Some of this feature are already implemented in the file-sync window.

Sample output:

Errors: 0
OK: 2, not found: 0, read error: 0, wrong checksum: 0

You can jump between errors/wrong checksums using the little arrows in the lower left corner of the Verify checksums window; also Ctrl+Up/Down do the same.

However, I agree that the window/feature could be improved further.

Regards
Dalai

Thank you Dalai