1. If I click the Options menu item, Lister indicates that the view is in Binary (2) mode! If I then select Binary mode (2) then TC shows the info in real binary mode.
2. If I select text (1) mode, the view looks amost like UTF-8 (7) mode.
3. If I select Unicode (6) mode the text looks ok (like initial view).
4. If I select Image/multimedia (4) mode and there is no plugin the text is displayed ok (like initial view). But when the Options menu is opened again TC indicates that the view is Binary (2)!
5. If I select Image/multimedia (4) mode and there IS a plugin, the plugin shows its info about the dir. If I then select Text (1) mode, the text is shown ok (like initial view). If I select Text (1) once again, the text is shown almost as UTF-8 view.
6. If I press F3 on a directory and click Options, the mode is shown as Binary (2) as mentioned before. If I then change to ASCII (S) mode the view is indicated as Unicode (6).
7. If I press F3 on a dir and press 1 twice the text is hard to read. If I then press 5 and then again 1, it becomes readable again.
8. If I have VisualDirSize installed as plugin, and press F3 , the dir info is corectly shown by the plugin. After that no matter whether I press 1, 2 or 3, Lister goes into Text (1) mode but shows the text correctly as in Unicode mode.
9. If I have VisualDirSize installed as plugin, and press F3, and then press 7 or 8 I get this access violation:
Code: Select all
---------------------------
Totalcmd
---------------------------
Access violation at address 00000000. Read of address 00000000.
---------------------------
OK
---------------------------