2
ts4242
Hi,
I recently tried your Buttonbar Editor in Windows 10 Pro (x64) Version 1703 (Build 15063.296) | Ultra TC Editors 6.30 Beta 1
and have noted the following in TC 9.0a (
only 64bit!):
When I change in TC 9.0a into a Sub-bar created with "Button Bar Editor.exe" with SHIFT + click on the button
and then click the "Back to main button bar" button (%Commander_Path%\DEFAULT.BAR)
then the icons "*" (Directory hotlist Ctrl+D) and "arrow down" (History Alt + Down) of these buttons
to the right of the TC editing line are no longer displayed or only displayed again when I point with the cursor on it.
These two icons are partially superimposed in the Sub-bar with a gray bar too,
which disappears when pointing with the cursor on it => also only in TC 9.0a 64bit.
In TC 9.0a 32bit everything works properly.
Please check. Thank you!
Regards
Karl
------------------------------------------------------------
/
EDIT
A few hours later and the spook is over
I can not reproduce the behavior even though it has occurred at least ten times before with TC 9.0a 64bit.
Therefore, please consider this post as irrelevant.
I'm sorry that I bothered you all with this.
------------------------------------------------------------
EDIT2
And the mistake is already there. It looks as if sometimes the error would "wander".
1x only on the left no buttons visible and on the left in the submenu the button partly gray superimposed,
then again only on the right no buttons visible and right in the submenu of the button partly gray superimposed.
But most often it is as mentioned above:
http://www.bilder-hochladen.net/files/big/lwdu-k-0d12.png
No error detected when using an empty test.ini.
Since I can not reproduce it reliably each time I leave it here as it is.