TC7rc5 - Multi-Rename Tool, Error: 'a' not a valid integer

[white]

* Open the Multi-Rename Tool.
* Enter "a" in the edit box "Step by".
* Press the Esc key.
* Open the Multi-Rename Tool again.

An error message is shown: 'a' not a valid integer value. Please report this error to the Author..

[StatusQuo]

Confirmed.
Entered letters seem to always work as value "1".

Since the given value doesn't work, I would expect a similar error message earlier -
maybe when moving the cursor out of this field (to be the least annoying).

[white]

Since the given value doesn't work, I would expect a similar error message earlier -
maybe when moving the cursor out of this field (to be the least annoying).

A similar error message which is asking if the program must be terminated, should not occur at all.

[Lefteous]

The strange thing is that it happens in the "step by" field but no in the "start with" field.

[white]

The strange thing is that it happens in the "step by" field but no in the "start with" field.

Not strange. Letters are supported in the "start with" field! However it is quite buggy. More about this later..

[Lefteous]

Argh

[CoolWater]

Confirmed. The ES_NUMBER style is missing...

Regards,
CW

[ghisler(Author)]

OK, no problem, I can catch that exception.

[Flint]

Fixed in TC7.0 final.

[ghisler(Author)]

Thanks!