TC 7.57 USB freeze system

yngpx · Post by *yngpx » 2012-03-09, 10:24 UTC

When I connect USB pen-drive, Total Commander 7.57 and system is freeze few seconds... System Windows 7 32 bit .
In Total Commander 7.56a is ok - no freeze

Post by *ghisler(Author) » 2012-03-09, 10:38 UTC

Not confirmed.

Here is what I tried:
1. Start TC 7.57
2. Place cursor on a directory
3. Press ENTER and keep it down -> TC switches quickly into the dir and back out of it (in a loop)
4. Insert USB stick

Result: TC keeps changing dirs all the time until the drive appears in the drive button bar, no freezing at all. Tested on Windows 7 32-bit and 64-bit.

yngpx · Post by *yngpx » 2012-03-09, 11:19 UTC

Ok - may be is only my configuration problem. When I connect usb pendrive and set active window Total Commander and change in total commander drive (to pendrive or C: or d: etc.) or click in panel (in active window) then is freeze system...
I check - may be my configuration error.
Thanks

Flint · Post by *Flint » 2012-03-09, 11:49 UTC

yngpx
So, freezing happens not when you plug the drive but when you change the drive? Try CheckUsbHdd=0 then.

yngpx · Post by *yngpx » 2012-03-09, 13:28 UTC

Flint wrote:yngpx
So, freezing happens not when you plug the drive but when you change the drive? Try CheckUsbHdd=0 then.

When I plug pendrive - total commander freeze in few seconds.

Post by *ghisler(Author) » 2012-03-09, 13:28 UTC

That will not help because CheckUsbHdd is TC8 only. Older versions didn't check for USB harddisks.

Maybe it's a problem with your virus scanner?

yngpx · Post by *yngpx » 2012-03-09, 14:30 UTC

Maybe it's a problem with your virus scanner?

Yes, I reflect... I upgrade Avast ver. 6 to 7

Thanks all for reply!

Flint · Post by *Flint » 2012-03-09, 17:04 UTC

ghisler(Author) wrote:That will not help because CheckUsbHdd is TC8 only.

Sorry, didn't notice it's 7.57 section…