Simple suggestion for brief view...

[Vansumsen]

After CTRL+Shift+F2

Try

1° Adjust de Width of the columns to your convenience
2° "CONFIGURATION" > "Save Settings" (or "position" ?)

It seems that when you come back in TC these settings are saved and don't disturbe the Settings for Full view or Brief view !
So you need not to adjust them each time.

With civility and prettiness you go more far...

Best regards

Paul

[Clo]

2Vansumsen
  Hello Paul !

• CTRL+SHIFT+F2 is dedicated to comments display...
• Special instructions for some other display-modes'ld be opportune. To add in <wincmd.ini>, of course.
• In the [Screen Resolution] section we have already:

Code: Select all

[b]DividerQuickView=500[/b]	
Position of window divider in permille, while the quick view panel (CTRL+Q) is shown. The two dividers can be set independently by choosing 'save position' in the appropriate mode (with and without quick view panel).

¤ Hoping that the Author'll have a look here...

  Kind regards,
Claude
Clo

[SamiRaj]

After CTRL+Shift+F2

Try

1° Adjust de Width of the columns to your convenience
2° "CONFIGURATION" > "Save Settings" (or "position" ?)

It seems that when you come back in TC these settings are saved and don't disturbe the Settings for Full view or Brief view !
So you need not to adjust them each time.

With civility and prettiness you go more far...

Best regards

Paul

Nononono, it doesnt matter if i save the position because if i resize Total Commander the Extension tab doesnt follow so it is hidden if i make totalcommander smaller in width and if i make it bigger its in the middle of the PANE or whatever it is called. Understand?

[Vansumsen]

2SamiRaj who says.... Nononono, .............. Understand?

Thanks for your message... zero for me... but this time I have understand...
Greetings
Paul