TC 8.51: MRT: Selected mask is not replaced but kept?

[Michael REMY]

tiny little bug in multirename tool

hi,

here a very little tiny but i saw since TC7 and still here in tc8.51 x64 :

when you open the multirename tool, there is already the maskname which is selected (which is fine, so keep it so).
then i click on a scheme button by example [YMD Date].
then the Date scheme is added in first position whereas it should replace the entire name (because there is already the full selected name at the openning).

that's all !
hope i cleary described it with my english.

i can tell it is a bug, because normaly in windows when a thing is already selected and have the focus on it, the first enter key always replace the pre-selected one.
In fact, you can reselect the entire name, and redo a button scheme, you can see that this time it works fine by replacing the whole selection name.

hope i cleary described it with my english.

have a good day

[Ovg]

2Michael REMY

Not confirmed, I can't reproduce this behavior. For me name is replaced by date ...

[Dalai]

Not confirmed here on Win7 x64 with TC 8.51a (32 and 64 bit).

Can you reproduce this with a clean wincmd.ini?

Code: Select all

totalcmd64.exe /i="%temp%\fresh.ini"

Regards
Dalai

[ts4242]

Confirmed on Win7 x64 with TC 8.51a x64 only.

[ghisler(Author)]

Not confirmed, TC 8.51a x64 on Windows 7 x64.

Is the [N] initially selected when you open the multi-rename tool?

[Michael REMY]

Not confirmed, TC 8.51a x64 on Windows 7 x64.

Is the [N] initially selected when you open the multi-rename tool?

yes it is.

if i enter a key (whatever) it replaces fine the whole [N]
but if i hit the button (from bottom choice) like TIME, dATE.., then it add it and get [D][N] whereas it should write [D]

[petermad]

Not confirmed with TC 8.51a 32bit and 64bit on Windows XP, Windows 7 x64 and Windows 8.1 x 64

[Horst.Epp]

Not confirmed with TC 8.51a 32bit and 64bit
on Windows 8.1 x64 and Windows 10 x64

[ts4242]

After some investigations i found that, to reproduce, invoke MRT from button bar or main menu not hotkey (Ctrl+M)

[petermad]

Confirmed when opening MRT from menu !

[Michael REMY]

After some investigations i found that, to reproduce, invoke MRT from button bar or main menu not hotkey (Ctrl+M)

i confirm my case , i always use the menu.
i tried from hotkey, and it does not append
so only from menu, you should retry it in previous version, because it is a lot of time i know it

[ghisler(Author)]

That's indeed very odd, I can confirm it too! I will try to find out in a debugger what is going on.

[petermad]

06.02.15 Fixed: Multi-rename tool: When opened via mouse, clicking on one of the buttons like [YMD] added the placeholder instead of replacing the selection (64)

Confirmed fixed i TC 8.52b1 64bit

[ghisler(Author)]

Thanks!

[Michael REMY]

Thanks!

you're welcome!