cm_Exit: force-switch if it have opened temporary files?

[Hurdet]

Do it is possible to have a switch to force cm_Exit also if it have opened temporary files?

[beb]

Do it is possible to have a switch to force cm_Exit also if it have opened temporary files?

What exactly that switch is supposed to do?

E.g., I mainly use cm_Exit as follows:

Code: Select all

[em_bitness] 
cmd=cm_ConfigSavePos,cm_exit 30
[em_restart]
cmd=cm_ConfigSavePos,cm_exit 29

where:
30 = 2+4+8+16
29 = 1+4+8+16
where:

Code: Select all

CM_EXIT supports the following parameters (sum of):
0 or no parameter: Just exit
1: Restart Total Commander
2: Restart Total Commander but switch between 32-bit and 64-bit versions (if the other exists in the same directory)
3: Note: 2 and 3 do the same thing
4: Save paths, directories, tabs, panels (brief, full, etc.), and display modes on exit even when it's disabled in the configuration
8: Pass the current left and right directories and file under the cursor to the new instance
16: Restart with full administrator rights (elevated) (32/64)

Both commands mostly allow you to get after restart in the same place where you were staying upon restart, sometimes including (sometimes not) multilevel archives (depending on what the archive was and at what stage of entering it restart occurred).
Downside: thereafter the unpacked temporary stuff should be deleted manually.

[Hurdet]

Do it is possible to have a switch to force cm_Exit also if it have opened temporary files?

What exactly that switch is supposed to do?

I have already written: if it have temporary files opened cm_Exit not work without close user confirm!