How to copy current directory path in Total Commander

[PeterCullenBurbery]

How do you copy the current directory path in Total Commander? For example,Image: https://i.imgur.com/gjafRTe.png

[Dalai]

There are several ways to do that.

• Put the command cm_CopySrcPathToClip on a button or in TC's start menu.
• Click somewhere behind the path on the path bar (the one that shows the current path) to enter editing mode which allows to copy the path. Note that if the breadcrumb bar is enabled, clicking on any part of the path changes directory to that part instead of entering editing mode.
• Press Shift+F6 when the cursor is on [..] (one level up) to enter the same editing mode as in the previous point.

Regards
Dalai

[petermad]

Keyboard only: press Ctrl+P (assuming that you have not assigned Ctrl+P to another command) - it will copy the path to the command line, where you can copy it from with Ctrl+C(after pressing the rightArrow key).

Ctrl+P is by default assigned to the cm_AddPathToCmdline command.

Click somewhere behind the path on the path bar (the one that shows the current path) to enter editing mode

Notice that there is a delay after the click, before the path gets editable.