[TC 11.50] Date not shown if it is located after attributes

[Galizza]

 
I've found a strange behaviour in Tc 11.50 Final - 32Bits.

The Wincmd.ini that i use in 11.50 is the same that i have been using
in 11.02 . I preffer that Tc shows Date/Time after Attributes, so in
Settings -> Tabstops/Data formats   I have these settings (that works
perfectly in Tc 11.02).

Extension - 168
Size - 226
Date/Time - 242
Attributes - 228
Comments - 96

But if i use these settings in 11.50 Date&Time are not shown.

I've tested it in 11.02 & 11.50 both with my Wincmd.ini and with a fresh
one (modifying only Tabstops/Data formats settings). Thanks.

Tc 11.50 32Bits // Windows 10 32Bits
 

[white]

Confirmed with 64-bit TC.
Seems to be introduced in TC 11.50b1.
Not sure if this is intended to be supported though.

[ghisler(Author)]

Not a bug: The date field is now length-limited due to the possibility to show seconds. Since the field is then too short, it would lead to an overlap with the attribute column.

[petermad]

Moderator message from: petermad » 2025-01-07, 09:46 UTC

Moved to "TC Behaviour which will not be changed" from "TC11.x bug reports (English)"

[ghisler(Author)]

While it isn't a bug, I found a solution for this specific problem: I just don't limit the field length if the date/time field starts behind the attributes field.

[petermad]

Moderator message from: petermad » 2025-01-08, 11:55 UTC

Moved back from "TC Behaviour which will not be changed" to "TC11.x bug reports (English)" - So it can be checked as working in the next update...

[ghisler(Author)]

This should be fixed in 11.51 RC1, please test it!

Don't limit the length of the date/time column if it's shown behind the attributes column

[Galizza]

 
Confirmed fixed in Windows 10 22H2 x86 + TC11.51 RC1 x86

Thanks

[white]

Confirmed that it now looks as before when using TC 11.51rc1 32-bit and 64-bit.

I did notice another issue which isn't new. The Attr header is aligned with the attributes in the file panel when using 32-bit TC, but not when using 64-bit TC. And in 32-bit TC there is no separator line between the Size header and Attr header when using normal mode (unlike when using dark mode).

[ghisler(Author)]

Thanks for confirming the fix!
Moved to fixed bugs.

The Attr header is aligned with the attributes in the file panel when using 32-bit TC, but not when using 64-bit TC.

Unrelated, and not confirmed.

[white]

The Attr header is aligned with the attributes in the file panel when using 32-bit TC, but not when using 64-bit TC.

Unrelated, and not confirmed.

With the tabstops settings mentioned in first post: Screenshot

[ghisler(Author)]

When the columns are out of order, the headers are undefined because you can't set a negative width.