Page 2 of 2
Posted: 2009-09-14, 17:11 UTC
by MVV
Partial wrote:How can I revert to old copy method?
I tried to enable and disable "Use standard copy method" in TC 7.50 RC1/RC2 but encryption stays when copying to another folder no matter what.
I checked all copy modes and may definitely say that if I copy files from encrypted folder to unencrypted:
* "Use standard copy &method (recommended)" enabled - E attribute preserved;
* "Use standard copy &method (recommended)" disabled (default method or big file copy mode) - E attribute cleared.
Posted: 2009-09-15, 09:41 UTC
by Partial
2MVV
you may read not only initial message but whole discussion (it's one page only) to see where problem appeared.
Posted: 2009-09-15, 12:22 UTC
by MVV
Partial wrote:2MVV
you may read not only initial message but whole discussion (it's one page only) to see where problem appeared.
As I see, other posts about 'how to change copy mode')) Yes, I might miss something, but if you wanted to draw my attention to some post it would be much better to specify post nunber instead of this pointless note.
Posted: 2009-09-15, 14:12 UTC
by Partial
2MVV
well, the pointless thing is actually two irrelevant posts instead of reading just one page.
Posted: 2009-09-15, 14:25 UTC
by MVV
Partial wrote:2MVV
well, the pointless thing is actually two irrelevant posts instead of reading just one page.
This post (my) is 5-th (I hope, last in this topic) pointless post. If I were you, instead of second pointless post I'd say something like 'thanks, I'd already solved my problem' instead of negative note that may cause disinclination to help you in future.